6
STEP 3
SETUP WASHER
After the washer has been properly installed there are still a few steps required before the washer is ready for
operation. Make the following revisions:
CS MODELS (COIN SLIDE)
These models are activated by coin slide in the control center. Install the coin slide (NOT provided with the
product) as follows:
First, remove coin slide actuator from accessory package that is found in the back of the coin vault.
Two (2) screws from the package attach the actuator bracket to the coin slide.
DISCONNECT ELECTRICAL SUPPLY.
1. Remove the service door from the control center. Remove the cover from
the coin slide opening.
2. Using a screwdriver, unscrew the bolt (located in the control center) from
retainer in front face of the control center.
3. Install the coin slide actuator to the new coin slide.
4. Using the adapter plate provided, install the coin slide into the control center
using locking bolt removed in Step 2.
5. Reinstall the service access door.
LOCKS AND KEYS
All keys coin box and vault security lock should be ordered from your commercial distributor.
MN MODELS (MANUAL NON-COIN)
Modification of control center is not necessary. Test washer through complete automatic cycle.
USER OPERATING INSTRUCTIONS
1. Insert coins until “select cycle” flashes in display.
2. Press fabric setting pad for wash cycle desired.
3. NOTE: Maximum clothes load capacity: MAT12 models—6.0 Kg; MAT13 models—7.5Kg Cottons.
Unscrew Bolt
