Command
Item
Key Combination
Description
Illustration
Setting
Upper
Limit
Setting
Favourite
Position
Program
Transmitter
using a
Programmed
Transmitter
Delete all
Original
Transmitters
Delete itself
from Motor
Charging
FAQ
Original Domlux & Cool Motion Basic Operation Continued
6
7
8
9
1
2
2
1
3
1
2
Press
UP
button on
transmitter
Press
STOP
button
when motor gets
close to end-point of
upper limit
Press either
UP
or
DOWN
button
Motor runs step by step to adjust
lower limit accurately.
Motor jogs up and down.
Limit Setting has been set.
Motor runs step by step to
adjust lower limit accurately
When motor reaches your
desired position: press stop.
Motor will jog again: Transmitter B
has been programmed
.
Motor stops.
Motor runs up.
Press
DOWN
button
Press and hold
LIMIT
button then press
UP
button
Press
STOP
button
when motor stops
Press
CONFIRM
button on
Transmitter B
Keep pressing
LIMIT
button on Transmitter
A, then press
CONFIRM
button
If nothing works, please check that the battery is fully charged
If the motor keeps running in the same direction continually, the setup limit needs to be re-set.
The motor works with a Li-ion battery, please charge it when the motor alarm goes off or when the
motor begins to falter. Please charge the motor using professional charger CH-8, 4V/1A.
Charging time: up to 4 hours or when indicator light turns green. Please disconnect from charger
when done.
Press
CONFIRM
button1 time to jog.
Keep pressing
LIMIT
button on the first pro-
grammed Transmitter
A, then press
CON-
FIRM
button
Press the
CONFIRM
button on transmitter
This can only be performed after setting motor limit.
Skip this step and proceed to the next one if the
subsidiary transmitter is not needed.
Motor will run to the favourite
position and stops.
Motor will jog, then release both
buttons.
This Transmitter has been deleted
from the motor.
Release both buttons once motor
jogs: now all transmitters have
been deleted except for
Transmitter A.
MaxxMotor Original-Instructions_Layout 1 20-02-06 10:30 AM Page 4
