Command
Item
Key Combination
Description
Illustration
Upper
Limit
Setting
Favourite
Position
Setting
Switch
Roller/
Horizontal
Mode
Horizontal
Mode
Trouble-
shooting
6
Press
UP
button
Motor goes up
9
Just Press
SETTING
button
Press
STOP
button
when close
to the upper limit
position
Press
UP
or
DOWN
button to adjust the
final position
7
8
Motor stops
1
2
3
Press
UP
or
DOWN
button
Press and hold
SETTING button
and then press and
hold UP button
Press
STOP
button to adjust the
finally position
Motor sounds DI-DI-DI: upper
limit setting has been set
Press
STOP
button when
blinds reach your favourite
position
Release both buttons when
motor sounds DI-DI-DI: the
setting has been completed
Motor goes to the
favourite position and stops
Press
SETTINGS
button on switch
3 times
, the working
mode has been changed from Roller to Horizontal or from
Horizontal to Roller.
Note:
The original factory setting is in roller blinds work
mode.
Adjust light:
press
UP or DOWN
button less than 2 seconds, motor rotate a certain angle so the blinds
moving step by step.
Normal moving:
press and hold the
UP or DOWN
button for 2 seconds, after which the motor will rotate
continuously towards upper or bottom limit end - otherwise press
STOP
if limit ends not set properly.
If nothing works, please check:
- whether the battery wand and motor are connected properly;
- whether the battery is charged - if not, recharge motor through wand
If the motor continues to run in one direction, please check:
- the limit setting which may have to be reset again.
MaxxMotor Original-Instructions_Layout 1 20-02-06 10:29 AM Page 2
