Visit: www.seekerwireless.co.uk for potential software updates
Attaching Antenna Mount Plate & LNB Park Plate:
1.
Remove antenna unit from wooden transit packaging
2.
Remove mounting plate from Antenna Unit by removing 6 x M6 nuts using 10mm spanner
3.
Clean roof, Mounting Plate and LNB Park Plate in accordance with adhesive manufacturer’s guidelines
4.
Mark a centre line for the antenna making sure dish will not overhang vehicle
5.
Align notches on plate with centre line
6.
Mark the position of 6 screw fixing holes
7.
Mark position of LNB Park Plate
8.
Drill 6 x 2.5mm pilot holes into the roof
Note:
• Follow manufacturer’s instructions when applying adhesive. Do not travel until adhesive has
cured noting that curing times vary with weather conditions.
• Take care when working at heights. Always follow ladder manufacturer’s safety advice.
• Use creeper boards where necessary to ensure roof construction can support your weight.
• Power tools should be used in accordance with manufacturer’s instructions
255mm 65cm (MXL003/65)
385mm 85cm (MXL003/85)
Direction of travel
Central Line
Antenna Mount Plate
LNB Park
Plate
Page 7
9.
Apply adhesive to entire surface of Antenna
Mounting Plate and LNB Park Plate and firmly
place them into position
10.
Place a small amount of adhesive into each hole
before screwing plate to roof
11.
Wipe off excess adhesive with a cloth
6 x No. 10
screws
