2
Thanks for purchasing Maxpro products. Please read the enitre manual carefully before using your X6-Plus
Specifications
Input power:
11~15V DC /15Amp (at maximum charge rate)
Charge current:
0.1~8.0A (0.1A/step)
Discharger current:
0.1~3.0A (0.1A/step)
Max. charge power:
150Watt
Max. discharge power:
15Watt
Balance charge current:
<400mA
Balance accuracy:
<10mV
Voltage tolerance:
0.10%
Capacity display:
0~9999mAH
Supported batteries:
1~6 cells Li-Po, Li-Ion, Li-Mn (2~6 cells in balance charge)
1~8 cells LiFePO4 (2~6 cells in balance charge)
1~18 cells NiMH, NiCd
1~12 cells(2~24V) Pb(SLA)
Temperature control:
Automatic fan speed
PC connection:
USB port
Additional functions:
Servo test (Linear, Speed, Deadband)
DC power supply (3.0~30V DC output)
Weight:
450g
Size(LxWxD)
145x100x40mm (5.71"x3.94"x1.57")
System Features:
Warnings:
1. High power, high current, high-performance power conversion circuit. Maxpro X6-Plus uses advanced DC/DC
converter technology with high output conversion efficiency
2. The X6-Plus can be used with four types of Lithium batteries (Li-Po, Li-lon, Li-FePO4, Li-Mn) and has a built-in balancer.
3. Optimized charge algorithm for NiMH/NiCd
4. Cooling FAN is controlled automatically by internal temperature sensor and provides intelligent protection.
5. 16*2 backlit LCD that displays the active mode, battery voltage, charge current, pack temperature, capacity (mAH
added or removed) and charge/discharge times.
6. Programmable charge settings.
Li** batteries: normal charge, fast charge, balance, storage, discharge, charge/discharge cycle, and battery monitor.
NiMH/NiCd & Pb batteries: charge, discharge, charge/discharge cycle.
7. Perfect protection. The X6-Plus has protection for reversed polarity (input or output), low input voltage, battery
temperature, charging capacity and battery voltage overrun.
8. Battery interinal resistance measurement with PC monitor software.
9. DC power supply mode can provide 3.0~30V adjustable DC to meet your requirement.
10. Built-in servo tester. Linear, Speed, Deadband of servos can be tested.
11. Firmware upgradable via USB port. The charge/discharge data can be recorded & analyzed by PC monitor software
& Battery analyzer software.
• Use a high quality power supply for input power source.
• Do not allow water, moisture, metal wires or other conductive material into the charger.
• Keep the charger away from children or pets at all times.
• Always be sure that the charger is properly configured for the correct battery type .
• Be sure that your lithium battery pack balance connector matches the multi-adapter type connected to the charger.
• Beware that the temperature of the charger shell & battery packs will increase during charge/discharge at high
power.
• Do not exceed the battery manufacturer's suggested maximum charge rates.
• Never charge batteries unattended.
• NEVER attempt to charge "non-rechargeable" cells.
• ACT charging mode should start with battery packs connected.
• Properly insulate and regularly inspect all connectors to eliminate the possibility of short circuit. Damage caused by
output short circuit is not covered by warranty.
• Do not open the case of the charger under any circumstances. Doing so will void the warranty.
