12
ACT Mode for NiMH & NiCD Operation & Display
No Battery
ACT
SERVO POWER
SETUP
NiMH
Activate
8S 2000mAH 1.0A
NiMH Activate
8
S 2000mAH 1.0A
NiMH Activate
8S
2000
mAH 1.0A
Press DEC & INC, Scroll through the setting within ACT, SERVO,
POWER, SETUP
START/ENTER
ESC/STOP
START/ENTER
ESC/STOP
START/ENTER
ESC/STOP
Press DEC & INC, Scroll through the setting within NiMH, NiCD
Press DEC & INC, Scroll through the setting of cell numbers.
Be Sure the cell numbers are configured correctly according to the
battery pack.
Press DEC & INC, Scroll through the setting of battery capacity.
100mAH/Step
Be Sure the battery capacity is configured correctly according to the
battery pack.
NiMH Activate
8S 2000mAH
1.0
A
START/ENTER
ESC/STOP
Press DEC & INC, Scroll through the setting of charging current.
0.1A/Step
Be Sure the charging current is proper for battery pack.
Starting charge
...............
START/ENTER
CC>10.90V 0.98A
20` 41mAH 0:02
“Charging Status”screen: the stage of the charge cycle (top left),
the pack voltage, the charging current, the pack temperature, the
capacity replaced and the time of charging.
CHG END 11.68V
20` 1988mAH 1:50
“Charging END”screen: the pack voltage, the pack temperature,
the capacity replaced and the time of charging.
You can press “STOP” to stop charging anytime.
ACT Mode can charge the NiMH or NiCD battery when the voltage can't be detected by X6-Plus, It allows the user to
override the voltage sensing and force the charge cycle to run.
Be sure you know the battery specification & characteristic very well before you use ACT Mode.
Connect the NiMH/NiCD Main wire Connector to X6-Plus.
Bu sure the connection is right. If X6-Plus can't detect the voltage.
Pls press "ENTER" to get the ACT Mode
