MaxPro PROFESSIONAL 111-1202, Руководство пользователя

Страница: 8 / 33

6 GB
Temperature and air volume se
According to the demands for temperature and air volume, push the switch to 1/2/3 and the heat gun
starts to makes a buzzing sound.
Paint removal
Install proper accessories.
Set air temperature to be high.
Start up the heat gun.
Directly point the heat gun at the paint to be removed.
When the paint is so ened, scrape the paint by using the scraping knife.
Do not use the tool to strip o ff adhesive fi lms on windows with metal frames because high temperature
may be transferred to glass and cause the glass to be burst. When the tool is used for remove the adhesive
films on the windo ws with the frames which are made of other materials, please use the shoveling knife.
Do not keep the heat gun at one point and spray heat for a long to prevent the surface from being set
on fi re.
Prevent paint from being concentrated on the scraping knife. Otherwise, it may be ignited. If necessary,
carefully use a small knife to remove the paint on the scraping knife.
Use in a fi xed state
The tool c an also be used in a fi xed state.
Put the tool on the working pla orm.
Fix the power line to prevent the tool from being separated from the working pla orm.
Carefully start up the tool.
Make sure that the nozzle is always kept far away from you and any onlookers.
Make sure that no object falls into the nozzle.
Temperature se
Turn ON/OFF switch to
Ⅰ
/
Ⅱ
, depending on temperature you need. Press any of the adjus bu ons
and the heat gun will start to buzz. Now you can increase or decrease the outlet temperature and air fl ow
gradually by pressing the bu ons ④. The LCD will display the temperature in digits and air fl ow in ladder
pa ern. Temperature in digits increase or decrease by every 10
℃
.
Cooling
During use, the temperature of the nozzle and the accessories becomes very high. Do not move or store
the tool un re cooled.
In order to reduce cooling adjust to level 1 for blowing cold air and let the tool run for several
minutes. Shut down the tool and let it be cooled for at least 30 minutes.
To reduce the cooling switch the tool to
Ⅰ
which is at the lowest air temperature and adjust
the air fl ow to Max. and let it run for a few minutes.
CLEANING AND MAINTENANCE
Please shut down the t ool and cut off the p ower before any maintenance is carried out.
Maintenance
The power tool is excellently designed, can run for a long term and only requires a very li of
maintenance. In order to achieve a con and sa sfactory working e ff ect, proper maintenance and
regular cleaning are required.
Lubrica
The power tool is not required t cated.
Cleaning
Keep the air vents of the machine clean to prevent the motor from being overheated.
Regularly clean the case b would be be er to clean the case a er every use.
If the dirt cannot be cleaned b y water.
Do not use gasoline, alcohol, ammonia water and the like. Otherwise, plas parts may be damaged these
solvents.