MaxPro PROFESSIONAL 111-1202, Руководство пользователя

Страница: 7 / 33

5 GB
Level III Weld thermoplas ti c plas ti cs, PVC floo rs, fabrics coated with PVC protec tion layers, PVC aw nings
and PV C films.
Bend pla s tic pipes and pl at es.
Weld tin, featured silver solder, SMD- building c omponen ts a nd cable t erminal s, and melt tin -
soldered seam joi nts.
Loosen ru s ty or fi x ed nuts and tig h t bolts.
Remove pai nt, old and thick oil l ayers or pai n t layer s and lime slur ry .
Sterilize a nd quickly disi n fect livest ock sheds by us ing 600DEG C hot air . Besides, the heat gun
c an be used for e ffecti vely resis ting the i n v asion of wood w orms. (A tt e ntion: Risk of Fire! Do not
overheat the surface of w ood.)
If you ca nnot ma k e sure the correct se tting , please fi rstly perform low-temperature se tting and the n
g r adually inc rease the temperatur e till the o p timum e ff ect is achiev ed.
Install correct accessories (if bought).
Ima g e Descrip tion Goal
Shov eling kni fe Prot ect glass when adhesi v e films on wind ow frames are
stripped o ff.
Hook Solder pipes.
Cir cular n ozzle W eld and shrink films (small-a rea hea ting).
Fla t n ozzle Dr y and melt (la r g e-area hea ting).
Scr aping kni fe Scrape o ff pain t t o brig ht en the sur f ace.
1. Mak e sure that the t ool is shut down and the n ozzle is c ooled.
2. A ft er the used accessories fall o ff , objects may be igni t ed. The accessories shall be in stalled on a fir m
machine.
3 . Serious sca lding may be caused if the extremely hot n ozzle is touc hed. The accessories shall no t be
in stalled or replaced u ntil the machine is fully c ooled.
4 . The extremely hot n ozzle may ign ite the base. The n ozzle which has no t bee n cooled c an be put on a
heat-resista nt base onl y .
5. If in correct or faulted accessories are used, reverse fl o wing of hot air may be caused and the m achin e
may be dama ged. Special original accessories f or the machine in the table ar e only all owed t o be used.
Ins tructions
Always follow safe ty in s tructions and appli cable law s and r egul a tions.
Hold the t ool with one hand. Do not put the other hand at the air ve n ts before opera tion.
In stall correct accessories for applica tion goals.
Set the required air temperatur e.
Startup and shutdown
If the heat gun is required to be started up, push the switch to 1/2/3. At the beginning of startup, a li ttle of
smo k e may rise from the hea t gun and this situ a tion is normal.
If the heat gun is required to be shut do wn, fi rstly adjust the temperature to be the lowest for c ooling and
then push the switch t o 0. Do not m ove or store the hea t gun until the he a t gun is c ooled.