Page 5 of 13
M-KIT112/113/114 Assembly Instructions
181-03005
These instructions must be followed exactly. Failure to follow these instructions could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulting from
failure to properly assemble the product in accordance with these instructions.
Maxon Furniture Inc.
Customer Service: 1-800-876-4274
Installing the Panels
1. Slide/pry the Top Cap from each Panel end
being careful not to damage the parts (Figure
1).
CAUTION! The following steps may
require assistance to complete.
2. Position the PL6636 Panels in their
approximate installed placement and level by
turning the glides on the bottom of the Panel
Frame with a 1/2 inch wrench.
3. On one PL6636 Panel, insert one Straight
Alignment Bracket into the notch located on
the panel’s edge at the bottom of the Panel
Frame (Figure 2).
4. Place one PLCP66 Corner Post on top of the
Straight Alignment Bracket.
5. Connect the PLCP66 Corner Post to the
PL6636 Panel by sliding plastic I-Beam Panel
Connectors down the grooves in between the
Corner Post and the Panel’s edge (Figure 3).
TIP! You will need 4 I-Beam Panel
Connectors to fill each groove.
6. Using wire cutters or snips, trim the excess
I-Beam Panel Connector length so that the
grooves are completely filled and flush with
the Panel Frame top.
7. Place one PL6636 Panel against the Corner
Post at a 90 ° angle from the first Panel.
8. Insert one Angle Alignment Bracket (Figure 2
& Figure 4) into the slots of the two Panels
being connected.
Tip! Use two slots near the bottom to
help eliminate interference with future
accessory installations.
9. While holding the Angle Alignment Bracket in
place, connect the second Panel by inserting
the I-Beam Panel Connectors as directed in
Steps 5 - 6.
Figure 1
Panel end
Top Cap
Figure 2
PL6636
Panel
PL6636
Panel
I-Beam Panel Connectors
PLCP66
Corner Post
Top View
Figure 3
Figure 4
Angle Alignment
Bracket
Straight Alignment
Bracket
Corner
Post
Glide
90 Exterior
Assembly View
Angle
Alignment
Bracket
I-Beam Panel Connectors
