Page 11 of 13
M-KIT112/113/114 Assembly Instructions
181-03005
These instructions must be followed exactly. Failure to follow these instructions could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulting from
failure to properly assemble the product in accordance with these instructions.
Maxon Furniture Inc.
Customer Service: 1-800-876-4274
Adding the Worksurfaces
1. Unpack the UCS2436TM Corner Worksurface
and unscrew the Cantilever Brackets from the
worksurface.
2. Position the Left-hand Cantilever Bracket into
left hand panel slots in the Back Left Panel at
about 28” from the floor (Figure 18).
3. With the Cantilever tilted up about 45 degrees,
slide the top tooth into the panel slot, then
rotate the cantilever down to engage the
other teeth (Figure 19).
4. Repeat Steps 2 - 3 to install the Right-hand
Cantilever Bracket on the right hand slots of
the Back Right Panel.
5. Add one RH Corner Bracket in the back corner
at the same height as the Cantilever Brackets
(Figure 20). The RH Corner Bracket is shown,
but you can use either the LH or RH Corner
Bracket.
6. Place the UCS2436TM Corner Worksurface
into position on the Cantilevers and Corner
Bracket.
7. Secure the UCS2436TM Corner Worksurface
with three #10 x 3/4” Panhead Screws in each
Cantilever and one #10 x 3/4” Panhead Screw
in the RH Corner Bracket (Figure 21).
Figure 20
Figure 19
Figure 21
Figure 18
RH Corner
Bracket
#10 x 3/4" Panhead Screw
(3 in ea. Cantilever,
1 in RH Corner Bracket)
28"
Left-hand
Cantilever
Right-hand
Cantilever
RH Corner
Bracket
Back Left
Panel
Back Right
Panel
Left-hand
Cantilever
