Maxon Intelimax+4G, Руководство пользователя

Страница: 48 / 94

In4G User Manual
- 48 -
Debug
The debug settings allow for additional debug levels to be set in the modem to allow for
additional debugging capabilities. When these debugging settings are enabled, the
Syslogs (system logs) contain additional information for either the engine or IP stack.
These should only be turned on for short periods of time while debugging and turned off
once debugging has been completed.
Lock out
The lockout configuration configures the GUI modem access control.
• Attempts: configures the number of incorrect login attempts the modem will
allow for before locking out any login attempts for the period. Between 0 and 10.
• Period: Timeout period before a login attempt can next be accepted.
Between 0 and 999.
• Session Timeout: Configures the length of time a session can be held
between the GUI and the modem. Between 0 and 10.
SNMP Configuration
Simple Network Management Protocol (SNMP) is the protocol governing network
management and the monitoring of network devices and their functions. It is not
necessarily limited to TCP/IP networks. The In supports SNMPv2 and SNMPv3, if
the ‘V3’ check box is ticked SNMPv3 is used o therwise SNMPv2 is used. In uses
Secure SNMPv3 SHA authentication and AES privacy. The administrator password should
be more than 8 characters long.
With the In SNMP customers can read the modem Signal Strength, registration
value, ecio, rscp, IMEI, firmware and module firmware values, as well as reset the modem
via SNMP MIB as shown below.
MAXON-MIB DEFINITIONS ::= BEGIN