GE-MARC - MANUALLY ENTERED CALL, Continued
If the signaling is unsuccessful, the radio is out of range or inoperative,
"NO SERV" will appear on the display, and a sequence of five beeps
will be heard at the speaker. Any subsequent attempt to initiate a call
within the next 20 seconds will be ignored. The radio can be cleared
from this mode by double clicking the M (Shift/Clr/Monitor) button.
All channels are busy when the signaling is unsuccessful and a one
second low frequency tone is heard at the speaker. The call will not
be retried automatically.
NOTE:
If the "call retry" option is active, the radio will try the channel
at twenty second intervals for five minutes before returning to the
normal System / Group display.
5. When the call is complete, double click the M (Shift/Clr/Monitor)
button to exit the Special Call mode and return to the normal
System/Group display.
STORING INDIVIDUAL/INTERCONNECT NUMBERS
1. Press SPC (special) key to put the radio into Special Call mode,
or key 7 to put the radio into Conference Call mode. The radio
displays the last accessed call number from the pre-programmed
special call selection. PHONE and the telephone handset icon
will display. If no special calls are programmed, the radio displays
"SPC CAL".
2. Enter the tone set (individual call) or telephone number to be
stored. The last digit entered will always be displayed in the far
right hand side of the display. Any previously entered digits will
scroll to the left. Only seven digits will be visible in the display -
the leading digit will scroll off the display with each new key
entry. To backspace and clear a digit, press the SCN key.
NOTE:
To recall the last interconnect number entered manually from
the keypad, press the RCL (recall) key.
3. Complete the entry by pressing the # key for individual calls
or the * key for telephone interconnect calls. They will not be
displayed but a tone will sound.
30
