EDACS - SQUELCH ADJUSTMENT
In normal operation, the squelch is automatically set by the radio and
does not need adjusting. If it becomes necessary to adjust the squelch,
use the following procedure:
Press and hold the M (Shift/ Clr/ Monitor) button. Use the up/down
arrow buttons to adjust the squelch - up arrow opens the squelch;
down arrow closes the squelch.
NOTE:
The radio must be on a Conventional System or an EDACS
working Channel (i.e. receiving a voice call) to adjust the squelch.
It is recommended that you adjust squelch from a Conventional
System.
SENDING A SPECIAL CALL
1. Press the SPC (special) key to put the radio into Special Call
mode and provide access to an alphanumeric special call list.
Each selection from the list is pre-programmed with either an
individual number or an interconnect number. If programmed,
the special call alphanumeric identifier will be displayed. The
PHONE and handset icon will be displayed while in the Special
Call mode.
2. Press the
up/down arrow keys to move through the special call list.
NOTE:
To display the last seven digits of the individual interconnect
number currently selected, press and hold the M (Shift/Clr/Monitor)
button and then press the SPC (special) key.
INDIVIDUAL CALL
- Once the desired individual special call number
is displayed, press and hold the PTT to initiate the call. The radio will
perform the required signaling to obtain a working channel.
When the signaling is successfully completed, the BUSY display
will appear and the call originate tone sounds. Speak directly into
the microphone. Release the PTT button as soon as you stop talking
and wait for a reply.
When the call is complete, double click the M (Shift/ Clr/ Monitor)
17
