SENDING A MANUALLY ENTERED INDIVIDUAL CALL
INDIVIDUAL CALL
1. Press the SPC (special) key to put the radio into Special Call mode
or key 7 to put the radio into Conference Call mode. The radio
displays the last accessed special call number from the pre-
programmed special call selection. PHONE and the handset icon
will be displayed. If no special calls are programmed, the radio
displays "SPC CAL".
2. Enter the tone set of the radio to be called. The last digit entered
will always be displayed in the far right hand side of the display.
Any previously entered digits will scroll to the left. Only the last
seven digits will be visible in the display - the leading digit will
scroll off the display with each new entry. To backspace and clear
a digit, press the SCN (scan) key.
NOTE:
To recall the last individual number entered manually from the
keypad, press the RCL (recall) key.
3. Press and release the PTT bar to initiate the call. The display will
show "WAIT" while the radio performs the signaling required to
obtain a working channel.
4. When the signaling is successfully completed, the BUSY display
will appear and the the proper DTMF tones will be sent and heard
at the speaker. When someone answers, press the PTT bar and
speak directly into the microphone. Release the PTT bar as soon
as you stop talking and wait for a reply.
If the signaling is unsuccessful, the radio is out of range or inoperative,
"NO SERV" will appear on the display, and a sequence of five beeps
will be heard at the speaker. Any subsequent attempt to initiate a call
within the next 20 seconds will be ignored. The radio can be cleared
from this mode by double clicking the M (Shift/Clr/Monitor) button.
If all available channels are busy when the call is attempted, a one
second beep is heard, and BUSY is displayed. The call will not be
retried automatically.
NOTE:
If the "call retry" option is active, the radio will display
28
