Installation & Operation for 12” (small) and 14” (medium)
1.) Before beginning assembly, installation or operation of
product, make sure all parts are present. Compare parts
with package contents list on previous page. If any part is
missing or damaged, do not attempt to assemble, install or
operate the product. Contact customer service for
replacement parts.
2.) Loosen 3 screws counterclockwise and remove lens (Fig. 1).
3.) Install the electrical box screws in the junction box (Fig. 2).
4.) Follow the correct Wiring diagram to connect wires from
luminaires to wires of Junction box.(Fig. 3).
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and any applicable
local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
WARNING:
RISK OF INJURY, RISK OF DAMAGE!
• Luminaire may fall if inner bezel is not secured properly to outer bezel. Ensure that the whole loop is positioned and
secured under the washer.
5.) Put the fixture plate across the screw of the lock in
(Fig. 2), then rotate fixture plate clockwise and lock it
tightly with the screw lock (Fig. 4).
6.) Select the desired color temperature at the CCT
switch (Fig. 5).
7.) Securely mount the lens to the fixture housing
(Fig. 6).
8.) Tighten 3 screw clockwise (Fig. 7).
9.) Restore power to the electrical box. Turn the light
switch on to activate the fixture.
Operating Instructions
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: [email protected]
Page: 5
REV: 11/19/21
MaxLite
LED ARCHITECTURAL CCT SELECTABLE
®
ML2LAxA Series
