Installation & Operation for 16” (large)
1.) Before beginning assembly, installation or operation of product,
make sure all parts are present. Compare parts with package
contents list on previous page. If any part is missing or damaged,
do not attempt to assemble, install or operate the product. Contact
customer service for replacement parts.
2.) Loosen 3 screws counterclockwise and remove lens (Fig. 1).
3.) Put two shorter mounting screws through Key holes of mounting
plate and lock the mounting plate to the junction box, then
install the two longer mounting screws to the drilled holes in
mounting plate (Fig. 2).
4.) Follow the wiring diagram to contact wires from luminaires to
wires of Junction box (Fig. 3).
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and any applicable
local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
WARNING:
RISK OF INJURY, RISK OF DAMAGE!
• Luminaire may fall if inner bezel is not secured properly to outer bezel. Ensure that the whole loop is positioned and
secured under the washer.
5.) Put the fixture plate across the two longer screws of the
locked in mounting (Fig. 2), then rotate fixture plate
clockwise and lock it tightly with the screw lock (Fig. 4).
6.) Select the desired color temperature at the CCT switch
(Fig. 5).
6.) Securely mount the lens to the fixture housing (Fig. 5).
7.) Tighten 3 screw clockwise (Fig. 6).
8.) Restore power to the electrical box. Turn the light
switch on to activate the fixture.
Operating Instructions
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: [email protected]
Page: 6
REV: 11/19/21
MaxLite
LED ARCHITECTURAL CCT SELECTABLE
®
ML2LAxA Series
