Maximum 054-7287-8, Инструкция по эксплуатации

Страница: 16 / 24

16
model no. 054-7287-8 | contact us 1-888-670-6682
7. In order to pull out the vacuum
adapter, lift the vacuum adapter
upward and then pull it out before
adjusting the tightening and locking
screws, as shown in fig 10e.
LED WORKLIGHT (fig 11)
The LED worklight will illuminate when
the trigger switch is pressed. This
provides additional light on the surface of
the workpiece for operation in lower light
situations.
GENARAL CUTTING
1. Firmly clamp the workpiece in place.
2. Use the appropriate type and size of
blade for the workpiece.
3. Check the clearance behind the workpiece and make sure that the blade will
not impact another surface.
4. Clearly mark the line of the cut.
5. Hold the saw firmly. Make sure that your hand is on the insulated gripping
areas only.
6. Rest the base plate on the workpiece so that the blade is not in contact with
the workpiece.
7. Turn on the jigsaw and bring it to the maximum desired cutting speed before
applying the blade to the workpiece.
8. Slowly move the jigsaw into the workpiece.
9. Do not force the tool. Keep the base plate flat against the workpiece while
cutting. Use only enough steady pressure on the blade to keep the saw cutting.
10. Reduce pressure as the blade comes to the end of the cut.
11. Allow the saw to come to a complete stop before removing the blade from
the workpiece.
12. If sawing fibreglass, plaster, wallboard, or spackling compound, clean the saw
motor vents frequently with a vacuum or compressed air. Always wear safety
goggles when cleaning tools using compressed air. These materials are highly
abrasive and may accelerate the wear on motor bearings and brushes.
OPER
A
TING INS
TRUCTIONS
1
2
fig 10e
Vacuum adapter
fig 11
LED
worklight