Maximum 054-7287-8, Инструкция по эксплуатации

Страница: 15 / 24

15
ADJUSTING THE BASE PLATE FOR
BEVEL CUTTING (
fig 10a, 10b, 10c,
10d and 10e )
1. Rotate the tool-less bevel lever to
unlock the base plate; refer to fig 10a.
2. Move the base plate backward so that
the base plate can be beveled; refer to
fig 10b.
3. The base plate can be beveled to the
left or to the right and has detents at
0, 15, 30 and 45°. Align the middle rib
with the mark on the base plate; refer
to fig 10c.
4. When the desired bevel angle is
achieved, move the base plate forward;
rotate the keyless bevel lever back to
lock the base plate.
5. Accurate work requires a trial cut.
Measure the work after cutting and
reset the angle as necessary. Repeat
the setting until the correct bevel is
achieved.
6. If the base plate will not tighten
as expected, you can adjust the
locking screw with a hex wrench (not
included). Loosen the tightening screw
with a screwdriver (not included), and
then tighten or loosen the locking
screw. Verify that the base plate
can move smoothly and will lock
as expecting after adjusting. After
adjusting, tighten the tightening screw
again. Refer to fig 10d.
OPER
A
TING INS
TRUCTIONS
NOTICE:
Remove the edge-guide locking knob before setting the 45° bevel
angle if necessary.
fig 10a
fig 10b
fig 10c
Middle Rib
fig 10d
Tightening screw
Locking screw
Forward