12
Machine plugs in and
turns on, but no display
in the LED.
1. The thermic overload
is cut off.
2. Machine is wrong.
1. Repaired by the specialist
2. Repaired by the specialist.
High decibel noise from
the pump
1.
air inside the pump
2.debris inside the pump
1. After fill water into the tank,
shake the machine for a few
times to discharge the air out of
the propeller of the pump.
2.Clean the machine and pump
according to How To Clean in the
manual (Or ask specialist to
clean the machine)
** During the use of the machine, if any other problems arise, please ask specialist to
check the machine. Do not attempt unauthorized repairs to avoid accidents.
Maintenance
To avoid burning, please make sure that the machine is power off and cool down to
room temperature before cleaning.
Place the machine vertically after cleaning, do not place it horizontally or upside
down
During cleaning, do not damage the components inside the machine. Once the
components are damaged, please ask specialist to check and repair. Do not
attempt unauthorized repairs to avoid accidents.
Abandon old water after each use, and fill with fresh water next time. If the
water is reused many times, some mineral substance may subside or adhere to
the surface of the components, thus influence the machine performance.
When you notice the discharge capacity reduce obviously or the machine
’s
components have much ash and dirts, please disassemble the stainless steel
housing (please refer to how to assemble and disassemble quickly) to clean
the heat tube and probe, it is better to clean every 20 times or 100 hours
working.