Copyright 2014 Maxford USA
Page 6
of 24 pages
#S140627
8.
Position the wheels on the axle. Secure the wheels onto the axle with 2 additional wheel collars
and a 1.5mm hex wrench.
9.
Secure the diagonal strut braces into their openings in the fuselage
with screws as shown at the right.
10.
Test-fit (
DO NOT GLUE
at this time) 6 mounting tabs into the fuselage.
11.
As shown below, test-fit and loosely attach the lower wing’s mounting brackets, cable anchors,
hex-head bolts and self-locking nuts to the fuselage’s mounting tabs. (NOTE:
DO NOT TIGHTEN
the
nuts on the bolts and
DO NOT GLUE
the 4 mounting tabs into the lower wing’s center section.)
12.
If you wish to install the optional windshield, cut through
the Mylar covering the slotted opening in front of the
pilot’s cockpit. Slide the windshield’s mounting base
down into its slot.
Nose
Fuselage
Fuselage
Cable anchors
