Copyright 2014 Maxford USA
Page 4
of 24 pages
#S140627
Return address:
Maxford USA
15939 Illinois Avenue, #B-C
Paramount, CA 90723
IMPORTANT:
Print the RMA# issued by Maxford USA
on your package
near our address.
III. SPECIFICATIONS
Wingspan ......................................................................................................................................................... 70 inches
Wing area ................................................................................................................................... 1,279 square inches
Length ................................................................................................................................................................ 49 inches
ARF weight ..................................................................................................................................................... 7 pounds
Ready-to-fly weight ....................................................... 12 to 14 pounds (depending on power system)
Power system .................................... .90 to 1.20 2-cycle glow engine; U638109 motor, or equivalent
Propeller ... Glow 16x8/10; EP 18x8 or 19x6; or as recommended by the power system’s maker
Radio ..................................................................................................................................... Minimum of 4 channels
Servos ............................................... 3 standard-sized servos (2 for the elevators & 1 for rudder) plus
2, 3, 4 or 5 mini servos as follows: Customer may use 1 mini servo on each of the 4 ailerons, or
customer may use 1 mini servo on each of only 2 of the ailerons; also, 1 additional mini servo
is needed for throttle control if a glow power system is used.
(Dimensions and weights are approximate.)
IV. PARTS LIST
1.
Included items
Radiator-grill hatch secured with magnets.
Prebuilt and covered fuselage, horizontal
stabilizer, elevators, vertical stabilizer,
rudder wings and ailrons, wing center
sectons & interplane struts.
Simulated full-length exhaust pipes.
Prepainted fiberglass cowl.
Scale stick-on markings.
Hardware package.
Adjustable electric motor mounting box.
(Note: Mounting box for a glow engine
is optional.)
Scale-looking landing-gear struts, wheels and articulated tail skid.
2.
Items you must supply to complete this ARF
Epoxy and cyanoacrylate (CA) adhesives and threadlock compound.
Low-tack masking tape and common tools (screwdriver, pliers, etc.).
A four- (or more) channel radio system; and, if customer uses all 4 ailerons, use four 12-inch
servo extensions; two 10-inch servo extensions; two 12-inch Y harnesses; one 6-inch Y harness;
4 mini servos for ailerons, 3 standard-sized servos for rudder and elevators; an electronic speed
control (ESC) for an electric power system or one additional mini-servo plus one 10-inch servo
extension for throttle control of a glow-engine.
Range of 0.90 to 1.20 cubic inch glow engine and compatible fuel tank, or a 1,200-Watt or
greater outer rotor motor with a compatible electronic speed control and battery.
16-inch diameter x 8- or 10-inch pitch propeller, or as specified for your engine or motor.
3.
Optional detail-upgrade items you may choose to add
Adjustable engine box for a
glow-engine power system.
Simulated pilot, observer
and 1 or 2 Lewis Guns.
Pilot’s windshield and
gunsight.
*
*
