No. Normal
Operation
Problem
Warning
Sound
Cause
What to Check
Solution
Tie-Wire is not set in
the tool.
Check if the Tie-Wire has
been set in the tool.
Set the Tie-Wire.
Four short
beeps repeated
(Pipipipi,
pipipipi, ...)
Binding wire not of
designated types
has been used.
Confirm reel side face.
Use MAX Tie-Wire
TW897A.
3. Trigger ON
→
Wire
sent out.
Sending of wire is
stopped halfway.
Three short
beeps repeated
(Pipipi,
pipipi, ...)
Binding wire has
been entangled
inside reel.
Confirm reel winding
Remove fray on reel.
4. Binding wire draws
a circle.
Curl is disordered
and steps out of
curl guide.
No sound
emitted.
Wire, by hitting
Reinforcing bars,
was repelled.
Check if wire hits Rein-
forcing bars at binding.
Pay attention so that
wire does not hit Rein-
forcing bars at binding.
5. Wire is subject to
cutting.
No wire cutting
takes place.
No sound
emitted.
Cutter section is
blocked with foreign
substance.
Confirm function of Cutter
section.
Either wipe Cutter
section with dry cloth or
blow it with air.
No sound
emitted.
Wire, by hitting
Reinforcing bars,
was repelted.
Check if wire hits Rein-
forcing bars at binding.
Pay attention so that
wire does not hit Rein-
forcing bars at binding.
(SEE PAGE 23)
Wire gets entan-
gled.
A short beep
and a long
beep, repeat-
edly.
(Pipipipipipi...)
Binding wire has
been entangled
around Twist sec-
tion.
Turn off power and take
out battery to confirm if
binding wire has been
entangled inside curl
guide.
Turning off power,
remove binding wire
inside curl guide.
Reinforcing bars is
not of designated
size.
Confirm size of Rein-
forcing bars to be bound.
(SEE PAGE 12)
Use appropriate diame-
ter scope.
Erroneous handling
such as improper
application of
Machine.
Confirm how to apply
Machine to Reinforcing
bars.
Turning Torque dial in +
and inserting in vertical
direction, use as tilting
at 45
°
. (SEE PAGE 22
AND 23)
Binding power is
weak.
No sound
emitted.
Function of curl
guide switch
Check if curl guide is left
open at binding.
Do not operate Machine
until binding is com-
pleted.
Reinforcing bars is
not of designated
size.
Confirm size of Rein-
forcing bars at binding.
(SEE PAGE 12)
Use appropriate diame-
ter scope.
Twisting-off takes
place.
No sound
emitted.
Erroneous handling
such as improper
application of
Machine.
Confirm how to apply
Machine to Reinforcing
bars.
Turning Torque dial in -
(minus) and inserting in
vertical direction, use as
tilting at 45
°
. (SEE
PAGE 22 AND 23)
Low power remains
in the Battery pack.
Confirm the battery is
fully charged.
Perform normal charge
after the tying speed
slows down considera-
bly.
6. Wire twisting takes
place.
Works properly
Two short
beeps.
(Pipi)
The tool is used at
low temperature.
Check the temperature at
the job site.
Leave the tool and the
battery pack at normal
temperature in the room
for some time, and then
continue the operation.
27
