4
2. GENERAL SAFETY WARNINGS
1.
WEAR SAFETY GLASSES OR GOGGLES
Danger to the eyes always exists due to the possibility of
dust being blown up by the exhausted air or of a fastener fly-
ing up due to the improper handling of the tool. For these
reasons, safety glasses or goggles shall always be worn
when operating the tool.
The employer and/or user must ensure that proper eye pro-
tection is worn. Eye protection equipment must conform to
the requirements of the American National Standards Insti-
tute, ANSI Z87.1(Council Directive 89/686/EEC of 21 DEC.
1989) and provide both frontal and side protection.
The employer is responsible to enforce the use of eye pro-
tection equipment by the tool operator and all other person-
nel in the work area.
NOTICE:
Non-side shielded spectacles and face shields
alone do not provide adequate protection.
2.
EAR PROTECTION MAY BE REQUIRED IN SOME ENVI-
RONMENTS
As the working condition may include exposure to high
noise levels which can lead to hearing damage, the employ-
er and user should ensure that any necessary hearing pro-
tection is provided and used by the operator and others in
the work area.
3.
KEEP HANDS AND BODY AWAY FROM THE DIS-
CHARGE OUTLET
When loading and using the tool, never place a hand or any
part of body in fastener discharge area of the tool. It is very
dangerous to hit the hands or body by mistake.
4.
DO NOT USE ON SCAFFOLDINGS AND LADDERS
Do not use on scaffoldings and ladders with fastener driving
tools equipped with contact actuation or continuous contact
actuation.
3. SAFETY WARNING
1.
WHEN USING THE TOOL, BE SURE TO USE A SPECIAL
AIR COMPRESSOR AND AIR HOSE
In order to improve its performance, it has set its working
pressure higher than the conventional nailers. To use the
tool, you always need the special air compressor and air
hose. Use of combusible pressure gas (for example, oxy-
gen, acetylene, etc.) causes abnormal combustion, possi-
bly resulting in explosion. Use only the special air
compressor and air hose.
2.
OPERATE WITHIN THE PROPER AIR PRESSURE
RANGE
The tool is designed to operate within an air pressure range
of 18 to 23 bar (250 to 320 p.s.i.).
The pressure should be adjusted to the type of the work be-
ing fastened. The tool shall never be operated when the op-
erating pressure exceeds 23 bar (320 p.s.i.).
TO AVOID SEVERE PERSONAL INJURY
OR PROPERTY DAMAGE
BEFORE USING THE TOOL, READ CARE-
FULLY AND UNDERSTAND THE FOLLOW-
ING "SAFETY INSTRUCTIONS". FAILURE
TO FOLLOW WARNINGS COULD RESULT
IN DEATH OR SERIOUS INJURY.
WARNING
18 bar
250 psi
23 bar
320 psi