
13
TRIGGER LOCK MECHANISM
The tool is equipped with a trigger lock mechanism. Push and ro-
tate the trigger LOCK to the trigger UNLOCK position before driv-
ing screws.
HOW TO REMOVE PLASTIC SHEET
As screws are driven the plastic sheet will feed out of the tool.
When sufficient strip has been fed out it can be torn away by pull-
ing against the tear edge in the nose.
RELIEF VALVE
This tool incorporates a high pressure reduction valve for reduc-
ing the range of pressure used at the PowerLine Hose side (18 to
23 bar (250 to 320 p.s.i.)) to a pressure around 8 bar (120 p.s.i.).
In a situation where the high pressure reduction valve fails and
pressure builds inside the tool, a relief valve will operate to re-
lease the pressure while emitting a sound. Because this shows
that the high pressure reduction valve has failed, immediately
discontinue use of the machine, disconnect the air supply, and
send it to be repaired by a MAX Co., Ltd.
authorized distributor or other specialist. Note that the relief valve
is built in to the rear part of the machine body.
METHOD OF CHANGING THE HOOK DIRECTION
•
ALWAYS disconnect the air supply before chang-
ing the direction of the hook.
The direction of the hook can be changed in four different direc-
tions, and the hook width can also be adjusted in two stages for
each direction. This allows adjustment in a total of eight patterns.
When changing the direction or width of the hook, use a hexago-
nal bar wrench 4 to loosen and remove the hexagon head bolt
that fixes the hook. After adjusting the hook position, replace and
tighten the hexagon head bolt.
Trigger lock dial
Relief Valve
(Built into the
inside of this part)
MOUNTING DIRECTIONS
WARNING
Hook
Mounting Hole
Hexagon
Head Bolt
Regulator