Maverick MV29995, Инструкция по эксплуатации

Страница: 9 / 52

9
Electronic Speed Control Setup
You must set up the ESC before running the fi rst time. Initial setup, it is not required
before every run.
Important !
Hold down the setup
button while turning on
the ESC. Release the setup button
once the Red LED starts to
fl ash
LED
Leave the trigger in the
neutral position.
Press the setup button. Move the trigger to full
throttle.
Press the setup button. Move the trigger to full
brake.
Press the setup button. When the process has
fi nished, motor control will be
activated in 3 seconds
LED LED LED
Green LED
fl ashes and a
Beep sound
comes from the
motor.
Green LED
fl ashes twice.
Beeps twice from
the motor.
Green LED
fl ashes three
times. Beeps
three times from
the motor.
No LED Lighting
If the LED on the speed control does not work as described below, the speed control may not be setup correctly. Repeat the
above process.
THE LED STATUS IN NORMAL RUNNING:
a) In normal use, if the throttle stick is in the neutral range,neither the red nor green LED will light.
b) The red LED lights when the car is run forward or backwards and will
fl ash quickly when the car is braking.
c) The green LED lights when the throttle stick is moved to the top point of the forward zone (full throttle).
Programmable Mode Settings
PROGRAM
PROGRAMMABLE VALUE
1 2 3 4 5 6 7 8 9
BASIC SETTINGS
1. Running Mode
Forward with
Brake
Forward/Reverse
with Brake
Rock
Crawler
2. Drag Brake Force 0% 5% 10% 20% 40% 60% 80% 100%
3. Low Voltage Cut-off Non-Protection 2.6V/cell 2.8V/cell
3.0V/
cell
3.2V/
cell
3.4V/
cell
4. Start Mode (Punch) Level 1 (Soft) L2 L3 L4 L5 L6 L7 L8
L9 (Very
Aggressive)
ADVANCED SETTINGS
5. Max Brake Force 25% 50% 75% 100%
6. Max Reverse Force 25% 50% 75% 100%
7. Initial Brake Force
=Drag Brake
Force
0% 20% 40%
8. Neutral Range 6% (Narrow) 9% (Normal)
12%
(Wide)
9. Timing 0.00 ̊ 3.75 ̊ 7.50 ̊ 11.25 ̊ 15.00 ̊ 18.75 ̊ 22.50 ̊ 26.25 ̊
10. Overheat Protection Enable Disable