30
Init Display First
Default: PCI Slot
Use this item to define if your graphics adapter is installed in one of the PCI slots, or if you
have installed an AGP graphics adapter into the AGP slot.
Power On Function
Default: Hot Key
KB Power ON Password
Default: Enter
Hot Key Power ON
Default: Ctrl-F12
The Power On Function item allows you to power on the system by pressing hot-keys, or
typing in a password. If you choose Password, you can use the item KB Power On
Password to install a power on password. If you set this item to Hot Key, you can then use
the item Hot Key Power On to choose which hot keys are installed.
Onboard FDC Controller
Default: Enabled
Use this item to turn on or off the floppy disk controller that is built into this mainboard.
Onboard Serial Port 1
Default: 3F8/IRQ4
This item lets you disable the built-in serial port 1, or enable it by assigning an I/O address
and an Interrupt Request Line (IRQ).
Onboard Serial Port 2
Default: 2F8/IRQ3
This item lets you disable the built-in serial port 2, or enable it by assigning an I/O address
and an Interrupt Request Line (IRQ).
UART Mode Select
Default: IrDA
This item defines the operation of serial port 2. In the Normal setting, serial port 2 is
assigned to the connector on the mainboard. If you have installed an optional infrared port,
you must change the setting of this item to one of the Infrared settings (usually IrDA or
ASKIR). These settings will disable the mainboard serial port connector and assign serial
port 2 to the infrared device. If you have selected an IR mode, two items appear,
RxD, TxD
Active
and
IR Transmission delay,
which let you set the duplex and transmission
parameters for the Infrared port. See the documentation of your infrared port for help on
these items.
Onboard Parallel Port
Default: 378/IRQ7
This item lets you disable the built-in parallel port, or enable it by assigning an I/O address
and an Interrupt Request Line (IRQ).
Parallel Port Mode
Default: SPP
This item defines the operation of the parallel port. As a default it is set to SPP (standard
parallel port). If you are connected to a parallel device that supports the higher-
performance EPP (enhanced parallel port) or the ECP (extended capabilities port) make the
appropriate changes to this item. If you change the parallel port to EPP or ECP, new items
appear to let you configure the EPP and ECP modes.
AC Resume After PWR-Loss
Default: Off
If this item is enabled, the system will automatically resume when power is restored after
an interruption in the power supply.
