9
5.
Swing the locking lever down and hook it under the latch on the side of the socket
to lock it in place.
6.
Locate the power connector for the processor cooling fan CPU FAN1. If your
processor has a cooling fan installed, connect the cable from the cooling fan to
CPU FAN1.
Install the Memory Modules
For this mainboard, you must use 168-pin 3.3V non-buffered Dual In-line Memory
Modules (DIMMs). The memory chips can be EDO RAM or SDRAM. The memory
bus runs at 66 MHz so you need not use PC-100 memory modules. You can use
memory modules that have a capacity of 16 MB up to 128 MB. Total installed
memory must not exceed 256 MB.
You can use memory modules which have memory chips on just one side (single-
sided) or memory chips on both sides (double-sided). If you install a double-sided
module in either DIMM 2 or 3, you must leave the other socket empty. DIMM1 is
independent and does not have this limitation.
1.
Locate the DIMM sockets on the mainboard.
CPU FAN1
DIMM Sockets
