Matrix S3X-02, Руководство по обслуживанию, Страница: 39 / 64

36
9.13 GENERATOR BELT REPLACEMENT
1) Remove both shrouds as outlined in Section 9.11.
2) Loosen the 6 screws holding the generator to the frame (Figure A).
3) Loosen the eye bolt nut that applies tension to the generator belt (Figure B) and slide the generator towards the back of the unit to release
the generator belt tension.
4) Walk the belt off of the generator pulley (Figure C).
5) Loosen the 2 eye bolts holding the center axle to the frame (Figure D).
6) Lift up on the center axle and walk the belt off of the drive pulley (Figure E).
7) This will allow you to drop the center axle out of the frame and to remove the generator belt (Figure F).
8) Reverse Steps 1-7 to install a new generator belt. NOTE: Tighten the replacement generator belt to 85 ft / lbs.
9) Test the stepper for function as outlined in Section 9.22.
FIGURE A FIGURE B
FIGURE D
FIGURE E FIGURE F
FIGURE C
CHAPTER 9: PART REPLACEMENT GUIDE