x 3
x 3
x 3
x 3
b
a
Ø6
2.5mm
STAGE 1
THRESHOLD
TOP VIEW
FIXED PANEL
WALL MOUNT
THRESHOLD
THRESHOLD
ADJUSTER
SILICON
THIS PAGE SHOWS THE PANEL INSTALLATION FOR A
LH CORNER. REVERSE FOR RH.
FIXED PANEL
WALL MOUNT
This stage is describing the fitting of the Fixed panel wall mount
Before fitting the enclosure please check that your product will fit the finished aperture size.(See dimensions)
a.
Place the horizontal threshold into position on tray, ensuring the threshold corner bracket is at the corner side of the enclosure (threshold
extrusion is unhanded, rotate by 180° to reverse hand). The threshold extrusion should be positioned
as close to the outside edge of the
tray as possible
, within the max and min side panel measurements (take into account that the front face of the fixed panel wall mount sits
2.5mm in front of the threshold when positioning at the front of the tray). Position the fixed panel wall mount on to the wall over threshold (wall
mount has a top and bottom, wall mount cut-out with socket set screw is the top of the wall mount). Ensure the threshold adjuster fits up into
the back of the wall mount extrusion in the recess as shown. Adjust position of threshold adjuster as required, to adjust loosen screw 1 full
turn, re-tighten after adjustment, do not over tighten. Plumb the wall mount for upright and mark the fixing holes in the centre of the slots.
b.
Drill 3 x fixing holes in the wall and insert wall plugs. Clean area and apply silicon sealant to the area behind the wall mount between the
tray and tiles and 100mm up the wall, central to the width of the wall mount. Fit the wall mount using the No.8 x 32mm Pan Head Screws.
THRESHOLD
CORNER BRACKET
TOP
