a
b
c
x 2
d
e
STAGE 9
ALL CAPS SHOWN ON THIS PAGE
CAN BE FOUND IN THE KIT OF PARTS
INSIDE
VIEW
This stage is describing the fitting of the Door Handle and cover caps and brace
a
.
Fit the Corner brace by fixing the top cap fixing into the side panel wall mount using the M5 x 20mm Csk socket screw
b
.
Remove the fixing in the corner extrusion end of the brace bar and push fit cap into the end of the top track, fixing into position using
the brace fixing screw. Insert screw cover into front face of top track (supplied in kit of parts).
a
.
Fit the 2 x door roller block covers (supplied in the kit of parts) to the back of the door roller blocks.
b
.
Disassemble the handle by unscrewing the 2 x M5 x 16 Csk socket screws. Place the glass washers either side of the 2 holes in the
door glass. Re-assemble the handle to the glass and tighten into position. Fit the Cover caps (supplied in the kit of parts) to either side
of the handle. For the 1000 model, assemble the handle with the M5 x 35 CSK screw. The Handle Inner is in the detail pack. The handle
is flush fitting on the outside of the door.
c
.
Fit the door guide screw cover (supplied in the kit of parts) to the door guide.
HANDLE INNER
IN DISK KIT
OF PARTS
MODEL
1000
ONLY
MODEL
1100 / 1200
1400 / 1500
1600 / 1700
