Rev.
Descrizione
Redatto/Gestito
Approvato
Cod.Ident.
Pagine
Data Em.
0.6
Manuale Istruzioni
GN
UTEC
B041.M01.EN
23
/47
07/2014
TOUCH-SCREEN CALIBRATRION
The touch-screen calibration screen will be as shown
hereinafter: WARNING IMPORTANT:
Once the calibration procedure has been activated, it
cannot be interrupted and have to be concluded.
How to calibrate the touch-screen
1. Keep on pushing the pen in the center of the viewfinder, wait
for the acquisition of the coordinates and for the movement of
the viewfinder to the next position.
2. Repeat the procedure described at point no. 1 for the five
positions (proposed in the following order: center, down on the
right, up on the right, up on the left, down on the left).
3. Confirm the calibration by touching the l’LCD or by
pushing the key
IMPORTANT:During the five phases proposed by
the procedure it is necessary to keep the pen
firmly as much as possible, in order to obtain a
correct calibration
CONNECTION CALIBRATION
The network connection
screen
shows
the
configuration
parameters
of
the
TCP/IP protocol set by
the operator (when the
DHCP is disabled) or
assigned by the DHCP
(when enabled).
Network connection
The change of the parameters
can be enabled pressing the
button
Close the screen
It annuls the
changes
It confirms
the changes
IMPORTANTE!
Per
una
corretta
configurazione
della
rete
rivolgersi
all’amministratore di rete o consultare
l’helpsheet esemplificativo.
Parametes
Value
DHCP
Select “Enabled” to activate the configuration of a dynamic IP address(assigned by the DHCP).
Select “Disabled” to activate the configuration of a static IP address (assigned by the operator).
IP address
This parameter available only when the DHCP is disabled. In this case, the operator can insert a valid
IP address
Subnet mask
This parameter available only when the DHCP is disabled
.
In this case, the operator can insert a valid
subnet mask.
Gateway
This parameter available only when the DHCP is disabled
.
In this case, the operator can insert the
gateway IP address. This parameter is not required if the machine is connected to a local network.
Indirizzo del server di
sincronizzazione tick
È utilizzato per effettuare la connessione al server che gestisce la sincronizzazione di più
dispositivi in rete. Inserire un indirizzo IP valido se è richiesta tale funzione.
PASSWORD
This screen allows to personalize the keys/password to access the
critical functions of the machine.
Parameter
Value
Profile Password
Enter a numeric value
Machine Configuration Password
Enter a numeric value
Channel Configuration Password
Enter a numeric value
Access Password (current
screen)
Enter a numeric value
Software Update Password
Enter a numeric value
IMPORTANT:
Refer
to
the
Administrator
for
a
correct
network
configuration or consult the relevant helpsheet.
It annuls
the
changes
It confirms
the
changes
