MT2466A 3 02/24/15
OPeratIOn
Always turn off the air supply, drain hose of air pressure
and detach tool from air supply before installing, removing or
adjusting any part or accessory on this tool, or before performing
any maintenance on this tool.
When using the metal blaster tool, be careful not to exert
excessive force. Too much force could be hazardous if it causes
the spindle to bend or break.
Excessive speed reduction indicates too much force being
applied to the work surface. Apply moderate hand pressure to the
tool and allow the accessories to do the work.
Avoid hazardous conditions by making sure the spindle screw is
tightly secured in the spindle.
NOTE: During operation, safety goggles should always be worn
(users & bystanders).
Do not use accessories which are not specifically designed
and recommended by the tool manufacturer. Never use
standard grinding wheels, wire brushes or cutoff wheels with
this tool. Correct wire belt and eraser mounting is necessary to
prevent injury. Do not use wire belts or eraser wheels that have been
broken or damaged in any way. Wheel hubs should be a free fit on the
spindle to prevent stress at the mounting location. Use only hubs that
come with the metal blaster for mounting wire belts and
eraser wheels. Flat washers or other adapters may over stress the
wheel hub. Always use factory recommended mounting
hardware. Tighten the wheel hub on the spindle to prevent spin off
when the tool is turned off and air supply disconnected.
mounting Wheels
When using Eraser wheels, #53 adapter set must be used.
ALWAYS use specified wheels for this kit.
1. Loosen # 52 spindle screw in center of wheel using supplied 3/16
"
hex wrench.
2. Unmount wheel and mount new wheel onto the spindle.
3. Tighten the spindle screw
MT2466A METAL BLASTER
