10. Make sure the encoder reader LED turns green at 0.5mm distance, as shown
below.
The LED turns green at 0.5 mm height
11. Move the C
ARRIAGE
to the right and to the left along the length of the printer,
checking that the green LED remains constantly lit, all the way, and that the
E
NCODER
R
EADER
does not touch the S
CALE
at any point.
If it touches the S
CALE
, readjust the height to 0.5 mm at this point, and run
another check along the entire beam, making sure again that the green LED
remains lit.
12. Shut down the printer.
13. Connect the X motor connectors.
14. Turn on the printer and perform INIT.
15. Check the L
INEAR
E
NCODER
check box in the E
NGINEER
dialog box.
16. Perform the following test to check that the E
NCODER
is working properly:
a.
Print the
Scale_for_LE.mjob
from
My Documents\Barak FE
.
b.
Compare the X measure with the print that was done in the beginning
of the installation. Both measures should be the same.
c.
If the last print is larger than the first one – the L
INEAR
E
NCODER
is not
enabled, re-check the option box in the E
NGINEER
window.
10100139 - C
© Matan Digital Printers Ltd.
Page 11 of 13
