Sticking the magnetic scale
Removing the sticky protective tape
13. You must now secure the M
AGNETIC
S
CALE
to the B
EAM
. This is done using the
two C
LAMPS
.
At the right end of the B
EAM
, insert the T-nut into the B
EAM
's groove, and
then insert the C
LAMP
into the same slot, above the T-nut.
14. Apply one or two drops of Loctite #222 onto the conical screw's thread and
tighten the screw, through the C
LAMP
, into the T-nut, as shown below.
10100139 - C
© Matan Digital Printers Ltd.
Page 7 of 13
Carriage Belt
Con Screw M6 x 16
T-nut (under the Clamp)
Clamp
Magnetic Scale
Beam
The right end of the Beam
15. Secure the left end of the S
CALE
to the B
EAM
, in the same way that you
secured the right side.
