3-3
Masterflex REGLO Digital Pump Drive with Advanced Connectivity
Section 2: Basic Setup & Settings
Masterflex
LOADING TUBING
Cassette Models
CAUTION
: Turn the drive off before removing or installing tubing. Fingers or loose clothing could
get caught in the drive mechanism.
The REGLO Cassette models use MS/CA Click’n’go cassettes for easy loading and removal, and to allow for
tubes with different diameters and materials to be used on the same roller-head. Cassettes are also available
with pressure levers. For further information see "
NOTE:
• Check to confirm that the rollers are clean and free of defects.
• Tubing should be clean and routed so that the bend radii are at a minimum of four (4) times the outside
tube diameter and are as short as possible.
• Use the appropriate tube diameter for the required flow rate and viscosity.
• Recalibrate tubing regularly to maintain the best flow rate accuracy (for further information see "
• After installing new tubing the pump should be run for 20-30 minutes to properly condition the tubing
and increase dispense accuracy (for further information see "
to condition new tubing
" below).
1. Remove the cassette by lightly pressing the fixing-tongue while simultaneously lifting the cassette.
2. Insert the tubing into the cassette:
a. Insert the first stopper of the color-coded three-stop tubing into the cassette’s front tube channel.
b. Allow the tubing to hang freely to prevent twisting.
c. Insert the second stopper of the tubing into the cassette’s rear tube channel.
3. Replace the cassette onto the roller-head.
STEP 1
STEP 2
STEP 3
