36
INTRODUCTION AND
GENERAL DESCRIPTION
The Masterflex
®
E/S
™
Auxiliary Power Pack Kit is intended to
provide supplemental 12V DC power to the Portable
Sampling Drives 07571-00 and 07571-05 in the field.
The Masterflex
®
Auxiliary Power Pack Kit consists of a fused,
current-limited, rechargeable, sealed lead-acid battery with a
current limited charger and carrying pouch. The Power Pack
plugs directly into the charger for recharging or directly into
the "External Power Input" port of the Portable Sampler to
provide supplemental power for extended operation of the
Portable Sampling Drive.
OPERATING DIRECTIONS
TO CHARGE THE AUXILIARY
POWER PACK
CAUTIONS:
Fully charge the unit (8 to 12 hours)
before using for the first time. Damage
to the battery pack can result if the
battery is fully discharged and
operation of the unit is attempted.
The Power Pack (battery assembly)
is continually powered. To prevent
accidental shorting of the coaxial
plug, a protective cap is supplied
with the unit. The protective cap
should be installed over the coaxial
plug when the Auxiliary Power Pack
is not in use. If this warning is
ignored, improper operation of this
unit can occur.
WARNING:
DO NOT use a battery charger other
than the one supplied with the
power pack to charge the battery. If
warning is ignored, damage to the
unit and personal injury can result.
A. Remove the protective cap from the coaxial connector of
the battery portion of the Auxiliary Power Pack and mate it
to the receptacle on the charger portion.
B. Connect the charger to an AC receptacle consistent with
the voltage listed on the charger.
C. Allow the unit to charge for 8–12 hours.
D. Disconnect charger from AC receptacle.
E. Disconnect battery from charger.
F. Reinstall insulating cap over coaxial plug.
CAUTION:
Excessive charging of the battery
will result in possible damage to the
unit and shortening of its useful life.
Do not charge battery for more than
24 hours.
USING THE AUXILIARY POWER PACK
TO RUN THE PORTABLE SAMPLER
A. Remove the protective cap from the coaxial plug of the
power pack (battery) and install connector into the
EXTERNAL POWER INPUT of the drive.
B. Toggle the EXTERNAL/BATTERY switch to the EXTERNAL
position.
C. Toggle the RUN/CHARGE switch to the RUN position.
D. Adjust drive controls for pumping direction and speed as
desired.
