19
CLEAR DATA LOG
Allows the operator to clear the data log. This is the only way
the data log may be cleared or erased. Once you have
selected the menu option and pressed ENTER, you will be
taken to a confirmation screen as shown below:
The default selection will not clear the data log. You must use
the up arrow to select "CLEAR ALL LOG DATA" and press
ENTER. Once the ENTER key has been pressed, the log will
be erased and the display will change to read:
Use the down arrow key to navigate and select DEFAULT
GLOBAL SETTINGS and press ENTER. The display will
change to read:
DEFAULT GLOBAL SETTINGS
Allows the operator to return all of the GLOBAL SETTINGS to
their default values.
If you have made changes to the GLOBAL SETTINGS and
lost track of the changes you have made or would just like to
start your changes from some common point, this option will
prove to be helpful. This option allows resetting of the
GLOBAL SETTINGS without having to track your changes or
remember what the default was.
To reset the GLOBAL SETTINGS you must use the up arrow
key to navigate and select RESET GLOBAL SETTINGS and
press ENTER. This confirmation of your selection to return
the settings to their default value is done to prevent accidental
or unintended changes to the global settings. Once you press
the enter key your previous changes will be lost and cannot
be recovered.
HINT: To exit the menu and return to a system ready prompt
use the cancel key.
HOT KEY
One option of the GLOBAL SETTINGS menu is also accessible
via a "Hot Key" located on the control console keypad. The
key is round, blue in color and labeled LIFT HEIGHT. This key
allows the operator to access the lift height setting in the
GLOBAL SETTINGS without going through the menu.
VIEW/ EDIT PROGRAMS
GENERAL
There are a total of 6 programs supplied with the Composite
Sampler. One program is a fluid transfer program called
CONTINUOUS PUMPING, this program cannot be modified.
The other 5 programs are fluid sampling programs. These
programs are numbered 1 through 5. All programs can be
accessed through the menu system of the Composite
Sampler. The 5 sampling programs can be edited to create
your own sampling programs. Edited or modified programs
must be saved before they can be run. Modifying the factory
supplied programs and saving them as modified programs
will temporarily overwrite the factory program. The factory
programs can be individually restored to their original default
settings upon demand.
Only (1) one program can be loaded and used at a time. A
program is always loaded into memory of the Composite
Sampler.
PROGRAM MENU TOUR
Operation of the system is menu driven. To access the menu,
if not presently displayed, press the MENU button on the
control console. The LCD display will show the following.
Use the down arrow key to navigate and select VIEW/EDIT
PROGRAMS and press ENTER. The display will change to read:
HINT: the display is only 2 lines, so you will only see 2
choices at one time. Remember the arrow in the first column
indicates whether there are choices above or below the ones
you are viewing.
c
CLEAR ALL LOG DATA
g
DON’T CLEAR ALL LOG DATA
g
LOG DATA
c
DEFAULT GLOBAL SETTINGS
c
RESET GLOBAL SETTINGS
g
DON’T RESET SETTINGS
g
GLOBAL SETTINGS
c
VIEW/EDIT PROGRAMS
g
PROGRAM #1
c
PROGRAM #2
