MasterCraft 054-1277-8, Руководство пользователя

Страница: 17 / 24

17
DRILLING
When drilling in smooth hard surfaces
such as metal, use a center punch to mark
the desired hole location. This will prevent
the drill bit from slipping off center as the
hole is started.
NOTES:
a) Use slower drilling speeds when drilling
larger holes.
b) Use a masonry bit when operating the
rotary hammer in hammer mode ONLY
when drilling in concrete.
ASSEMBLY AND OPERATING
For safety reasons, the operator must
read the sections of this Owner’s
Manual entitled "GENERAL SAFETY
WARNINGS", "POWER TOOL
SAFETY", "SPECIFIC SAFETY RULES",
"EXTENSION CORD SAFETY" and
"SYMBOLS" before using this rotary
hammer.
Verify the following every time the
rotary hammer is used:
1. Safety glasses, safety goggles, or
face shield is being worn.
2. Hearing protection is being worn.
3. The chuck, drill bit and
accessories are properly installed.
4. The bit is in good condition and is
properly tightened into the SDS -
plus
®
clamp or chuck.
Failure to observe these safety rules
will significantly increase the risk of
injury.
WARNING
!