Master-force 241-0314, Руководство оператора

Страница: 12 / 16

Page 11
OPERATION
INSTALLING bITS (fIG. 5)
1. Lock the trigger switch by placing the
direction of rotation selector in the
OFF (center) position.
2. With one hand, pull the sleeve toward
the front of the tool, and hold it in place.
3. With the other hand, insert a 1/4-in. bit
into the hexagonal hole in the bit
retainer.
4. Release the sleeve and check that it
returns to its original position.
WARNING:
If the sleeve does not
return to its original position, the bit is not
correctly installed. Retry until the bit is
properly installed.
NOTICE: When the bit diameter is larger
than 1/4 in., use a suitable adapter
(available separately) to install the bit.
REMOVING bITS (fIG. 5)
WARNING:
Use protective gloves
when removing the bit from the tool, or
first allow the bit to cool down. The bit
may be hot after prolonged use.
1. Lock the trigger switch by placing the
direction-of rotation selector in the OFF
(center) position.
FIG. 5
2. Pull the sleeve towards the front of the
tool, and hold it in place.
3. Remove the bit from the hexagonal
hole in the bit retainer.
4. Release the sleeve.
TIGHTENING AND LOOSENING
SCREWS AND NUTS
1. Install the correct bit.
2. Apply just enough pressure to keep the
bit engaged on the screw or nut.
3. Apply minimal pressure to the trigger
switch initially. Increase the speed only
when full control can be maintained.
NOTICE: This driver is equipped with an
electric brake. When the brake is
functioning properly, sparks may be
visible through the vent slots in the
housing. This is normal and is the action
of the brake.