Masport CARDRONA ACC, Руководство пользователя и инструкция по установке

Страница: 3 / 20

WARNING.
Installation of all gas appliances MUST be carried out only by an Authorised Installer.
The heater must be installed according to these instructions and in compliance with all
relevant building, gas-fitting, electrical and other Statutory Regulations (e.g. AS 5601 (AG-
601), NZS 5261). Any shortcomings in the appliance and flue installation will be the
responsibility of the installer, and Masport Ltd will not be accountable for any such failings
or their consequences.
The guard is fitted to this appliance (Australia only) to reduce the risk of fire or injury from
burns and no part of it should be permanently removed. For the protection of young children
or the infirm, a secondary guard is required.
These appliances must not be installed in mobile homes.
NOTE: NOT INTENDED FOR FIREPLACE INSERT.
YOUR HEATER MUST BE SERVICED YEARLY BY AN AUTHORISED TECHNICIAN.
BEFORE INSTALLATION COMMENCES, check the data plate on the rear of the heater
cabinet to verify that it is the correct type to suit your gas and also that the gas consumption
rate is correct for your application.
ECS MODELS. The aerial wire is intended to protrude through the slot in the rear of the
pedestal. DO NOT PULL this wire as this will dislodge the aerial circuit board.
IF THE APPLIANCE REQUIRES CONVERSION TO SUIT YOUR GAS, THIS MUST BE
CARRIED OUT ONLY BY AN AUTHORISED TECHNICIAN WHO HAS THE
APPROPRIATE GAS PRESSURE MEASURING EQUIPMENT.
____________________________________________________________________
OPERATING INSTRUCTIONS
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
LIGHTING AND RUNNING THE FIRE:-
• Open the gas supply valve behind the appliance, if fitted.
CAUTION: If the fire has been alight, wait two to three minutes before re-lighting it.
NOTE - There may be a strong smell of paint curing the first time the fire is lit, but this will disappear.
LIGHTING STD MODELS:-
• Press down on the control knob at the top of the heater and turn it anticlockwise to the ‘PILOT’
position. Holding the control knob down firmly, press the igniter button. The battery igniter will
generate a continuous spark across the terminals at the pilot. If there is no spark, check the
1