Mash Adventure 400cc, Руководство пользователя

Страница: 29 / 42

XY400GY
-28-
Overheating of the braking system may cause failure
in extreme conditions.
Examination of rear brake fluid level
The reservoir of the rear brake disc is set up on rear brake
pump of the right side of the motorcycle
No air bubbles emerging from the liquid should be found in
the observation mirror when the motorcycle is parked
vertically.
Warning
If the brake fluid level drops below the minimum level,
probably it indicates that the braking system has a leak
or the brake pads are completely worn out. In this case,
please consult your authorized Shineray dealer.
Refilling the rear brake fluid reservoir
Add the brake fluid until a bubble appears in the
observation mirror. Remove the bolt
【
2
】
from the top,
then fill the brake fluid up the mark inside the reservoir.,
and remount the bolt. Spilled brake fluid must be rinsed off
with water.
Warning
- Never use DOT5 brake fluid.
- Store the brake fluid out the reach of kids
-Brake fluid can cause skin irritation. Please avoid
any contact with skin and eyes. If you get the brake
fluid in your eyes by accident, rinse with water and
go to doctor immediately
Caution:
·
Use only clean brake fluid taken from a tightly
sealed container.
·
Please avoid the brake fluid splashing onto the
stickers, paint and rubber components.
Examination of rear brake pads
The brake pads can be inspected backwards. The
thickness of the linings may not be less than 1mm.
Warning
Linings should not be thinner than 1mm at the most
worn out part of the pads. Otherwise it could cause
failure of braking. For your own safety concern,
please have your brake pad replaced immediately if
necessary.
Caution:
If the replacement of the brake pads is performed too
late, partly or entirely causing the wear-out of the
lining, the steel components of the brake pad will rub
【
2
】