Mash Adventure 400cc, Руководство пользователя

Страница: 17 / 42

ADVENTURE 400cc
-16-
C. Requirements
1). Never fully open the throttle when the new motorcycle
has not been ridden for more than 1000km.
2). When riding in each gear, the speed should less than 80%
of its allowed speed (the opening of the throttle should
be less than 80%), and shift the gear in time.
3). Do not let your engine bear too much load in the first
1000km.
If the start fails
If the engine can’t be started, or the motorcycle is not
moving, the points below should be checked
：
·If there is fuel in the tank
·If the motorcycle is properly operated according to the
instruction book shows
·If the fuse is melted
·If the engine start button is working properly
·If the battery is finished with power which cause the engine
start button not working, please try the kick start.
Operation of E-start
I
t would be better to use the E-start when the gear is neutral,
of course, you can activate the E-start at any gear as well.
However, be sure that the clutch is disconnected (hold the
clutch lever tight), and be noted that the lasting operating
time of the E-start must not exceed 15 seconds. If the battery
is low (lower than 10.5 V), you just need to ride for a few
kilometers and charge the battery.
The correct operation of the gearshift mechanism:
The gear position of the engine is 1-0-2-3-4-5-6. The
gearshift type is international with 6 gears. The shift of gear
must be properly controlled in accordance with the road
conditions, loading status and the speed.
5
、
Switches on handlebar

Headlight
、
Position Indicator
Turn the main switch key to “ON” position
，
switch on the
headlight
。
Position Function
position indicator and taillight ON
●
Headlight switch off
·Position indicator shows its position to the nearby Vehicles;
and reminding other vehicles when wait at crossroad, to
avoid Confusion.
Headlight Switch

Far and Near Light Lamp Instruction
Sliding Switch up and down to use Far and near light lamp.
（ ）
headlight on full beam
（ ）
headlight on lower beam
Far and near light switch

Direction Indicator
Use indication switch when turning Left and right.
＜
Usage
＞
If put main Switch on position, the indicator will
wrinkle.
Slide Direction indicator can stop the turning signal
Operation.

（
R
）
Turn Right

（
L
）
Turn Left