40
41
5 -10 mm
2
2
1
1
1
1
2
2
3
3
4
4
Adjusting the play of the throttle cable
Caution
When the throttle cable free play has been adjusted, check the throttle grip for
proper operation. The setting will have no effect on the engine idle speed, and the
handle will automatically return to the closed position.
Clutch adjustment (guard)
Clutch adjustment is made by adjusting the tension of the clutch cable. Before
disengaging by pulling the clutch lever, the cable play measured at the clutch lever
should normally be 10 mm. If the measured value is different, adjust as follows.
Loosen the nut (1) and turn the tension ring of the lever (2) fully clockwise.
Unscrew the lock nut of the cable tension ring (5), before turning the ring (4) in one
direction and then in the other until the play of the lever reaches approximately 4 mm.
The lever adjustment ring (2) can optionally be used to fine-tune the adjustment. Once
the adjustment has been made, retighten the locknut (1) and the ring (5), then wrap
them with the rubber sleeve (3).
1. Loosen the lock nut.
2. Turn the nut so that the cable play is between 0.5
and 1.0 mm.
3. After adjustment, retighten the locknut.
1. Lock not 2. Adjusting nut
Adjusting the transmission chain
To adjust:
1. Secure the motorcycle on its side stand or center stand (if equipped).
2. Loosen the nut on the rear wheel axle.
3. Loosen the lock nut.
4. Turn the adjustment bolt left or right to achieve the desired adjustment.
1.Adjustment bolt
2.Lock nut
3. Alignment mark
4. Rear wheel axle nut
Note: When installing a new chain, it is
necessary to check the pinion and crown. It
is advisable to replace the chain kit.
The tension of the drive chain should be
adjusted every 1000 km so that the play is
between 20 and 30 mm.
Caution
The closed (rounded) part of the chain
quick release clip should face the direction
of chain rotation.
1. Quick chain clip
2. Direction of rotation
Cleaning and lubricating the drive chain
The accumulation of dirt on the drive chain can worsen its wear and that of the
sprockets. It is therefore strongly recommended to clean the chain every 1000 km
using a cleaning solvent, then grease it with a special lubricant or engine oil.
Reference: IPONE: Chain Cleaner / X-TREM Chain Road.
