2
62
Understanding the Vehicle
System with Devices Provided
with Rolling Codes
Programming the Hand-held
Transmitters Manufactured after 1995
These devices can be identified by the
“LEARN” or “TRAIN” setting button
located where the hanging antenna
is attached to the garage door/gate
opener. It is NOT the button that is
normally used to open and close the
door.
The name and color of the button may
vary by manufacturer.
• Place the ignition device to the
RUN
position without starting the engine.
• Place the hand-held transmitter 5
- 30 cm (1 to 3 inches) away from
the HomeLink
®
button you wish to
program.
• Simultaneously press the Homelink
®
button you want to program and the
hand-held transmitter button.
• Release immediately the Homelink
®
button you want to program.
• Continue holding the hand-held
transmitter button until the warning
light starts flashing quickly; then
release the button.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
®
system.
NOTE:
The distance necessary between the
portable hand-held transmitter and
the HomeLink
®
in the vehicle depends
on the system you wish to program.
Probably it will be necessary to try
several times. Upon every attempt,
keep the setting position for at least
15 seconds before trying again.
Synchronising the Rolling Codes
At the end of the previously-described
programming, if the HomeLink
®
has been programmed for a rolling
code system, it will be necessary to
synchronise it to ensure its correct
operation.
• Locate the “LEARN” or “TRAINING”
setting button of the opening motor.
Firmly press it and then release it. On
some garage door openers/devices
there may be a light that blinks when
the garage door opener/device is in
the LEARN/TRAIN mode.
NOTE:
You have 30 seconds to initiate the
next step after the setting button has
been pressed.
• Return to the vehicle and press the
programmed HomeLink
®
button for
two seconds and then release it.
• Repeat this operation a second time.
If the garage door opening device
activates, the programming/
synchronization phase is complete.
NOTE:
If the garage door opening device
does not activate, press the button
a third time for two seconds and
then release it to complete the
programming/synchronization phase.
• To program the remaining two
HomeLink
®
buttons, repeat the same
step for the same remaining button.
DO NOT erase the channels.
Reprogramming a Single HomeLink
®
Button
To reprogramme a channel that has
been previously trained, follow these
steps:
• Place the ignition device to the
RUN
position without starting the engine.
Содержание Ghibli 2021
