Mase IS 2.7 B, Инструкция по использованию, обслуживанию и монтажу

Страница: 32 / 44

IS 2.7 B
- 32
GB
GB
ON / OFF
START
SCROLL UP
- MENU SCROLL
DOWN -
MENU
SELECT
F
1
F
2
F
3
F
4
F
5
5.4 F
USES
@ @
@ @ @
- Protection module fuses
On the printed circuit of the engine protection module
there are five fuses to protect the module. Remove the
frontal panel unscrewing the 4 screws to enter in it.
F
1
: 5A 5x20mm for relay “ALARMS”
F
2
: 5A 5x20mm for relay “IP” (insulated poles)
F
3
: 5A 5x20mm for relay “RUNS”
F
4
: 5A 5x20mm for relay “GLOWS”
F
5
: 5A 5x20mm for relay “EV” (solenoid)
5.3 E
NGINE PROTECTION MODULE
CBU device (Can-Bus transmission unit) controls
and driving the genset.
Large display and the control push-buttons allow an
easy use and monitoring of the CBU unit.
Displayed information
- Voltage Vac
- Frequency Hz
- Hourmeter
- Battery voltage of the genset
- Voltage of onboard batteries
- Low oil pressure alarm
- High engine temperature alarm
- High alternator temperature alarm
- Displayed stop alarms
- Storage and back-up of alarms
- Maintenance (first 50 hours)
Input / Output signals - Commands - Checks
- Connector mod. 485 for MODBUS protocol
(It allows monitoring and driving the genset by
the boat main control monitor)
- Output all included alarms (optional)
- Input voltage of onboard batteries (from 12V
up to 24V) (optional)
- Input battery voltage of the genset
- Input Start/Stop from remote panel
- Switch off button
- Scroll through display buttons
- Emergency pushbutton (predisposition)
The low oil pressure protection does not give an
indication of the oil level. The oil level must daily be
checked in order to prevent damage to the engine.
The engine correctly works if it doesn't exceed inclina-
tions max of 30° for up to 3 minutes and 25° without
limits of time, in comparison to both longitudinal and
transversal axles. If the engine works to greater incli-
nations, it risks an insufficient lubrication and/or aspi-
ration of oil from the filter air.
If one of the above safety switches trip, find and
eliminate the cause and then press the STOP button
to reset the control panel (otherwise the signal still in
memory inhibiting engine starting).