IS 2.7 B
- 19
GB
GB
3
mm
[in.]
2
1
3 INSTALLATION
The generator may only be installed by qualified
technicians. Malfunctioning due to improper
installation may cause injury or death.
3.1
GENERATOR
HOUSING
CHARACTERISTICS
- The generator must be installed in a sufficiently
ventilated room able to assure the amount of air required
for engine combustion.
- The room must be acoustically separated and isolated
from the living quarters.
- The generator must be positioned in such a way as to
facilitate normal maintenance operations.
- It is advisable to install the generator in the
propulsion engine room provided that it meets the
above conditions.
- The air must be clean.
- The air temperature in the place of installation must be
between -5°C
(23°F)
and +40°C
(104°F)
.
- The relative humidity must not exceed 50% at a
maximum temperature of +40°C. Relative humidity of 90%
at +20°C
(68°F)
and 100% at +25°C
(77°F)
is
permissible.
3.2 L
IFTING
Follow the procedure below to lift the generator:
- Place a homologated lifting strap of adequate capacity
(
ref. 2
) around the exhaust manifold (
ref.1
).
- Lift and handle with attention. See also
chap. 7.2
3.3 A
NCHORING
THE
GENERATOR
To anchor the generator, arrange a base to support the
weight and vibrations.
Drill holes in the base as shown in
fig.3
.
3.4 V
ENTILATION
The generator is equipped with an internal forced cooling
system through a water/air exchanger.
The amount of air required for combustion is
aspirated through the intake located on the base (
ref.4
):
Therefore, always check that this intake is
free of any obstruction.
Содержание IS 2.7 B
Страница 2: ...IS 2 7 B 2 GB GB...
