Mase IS 2.7 B, Инструкция по использованию, обслуживанию и монтажу

Страница: 27 / 44

IS 2.7 B
- 27
GB
GB
C
ONNECT AN EXTERNAL BATTERY PACK TO
CBU
It is possible to connect a 12-24V external battery pack to
CBU and show Voltage on display.
CBU : generator control module
CN4 : connector, Molex 12 polesfemale holder onboard
module.
A : external battery pack. 12-24V (not included)
B : fuse 1A (not included)
C : cable terminal Minifit female (not included)
On the rear side of CBU module, connect battery EXT to
CN4 connector using following terminals ( ref.C ),
at n°6 +Vext and at n°12 -Vext .
ATTENTION: It is possible to have this type of connection
only on the main CBU module.
3.7.3
A
.
C
.
CONNECTION
This connection can be made by means of the power
terminal board (
ref.1 ).
Generator earthing. High voltage may cause serious
injury or death.
Electroconduction is possible whenever electricity is
present.
De-energise the main magnetothermal switches
of all the power outputs before repairing the equipment.
Configure the installation for earthing of the generator
and the electrical circuits when in use.
Avoid contact with the electrical conductors or equipment
when standing in water or on wet ground, since there is
a higher risk of electroconduction in these conditions.