MASCOT MSTWW, Инструкция по установке и эксплуатации

Страница: 13 / 68

Mascot ST Tankless Water Heater Page 11
4.2 Wall Mount Bracket
• 4.2.1 The installation height and location for your
Mascot ST depends on your installation scenario. With all
clearances considered, and given adequate positioning for
air supply and venting, you will need to determine the best
position to mount the Wall Mount Bracket. The wall must
be concrete, wood, or plywood over studs, and must be
strong enough to hold the water heater!
• Start by familiarizing yourself to how the
included Wall Mount Bracket hooks underneath
the two Hangers that are attached to the back
of the water heater. The ‘hooks’ of the Wall Mount
Bracket will be 3” from the Top of the water heater once
the water heater is hung.
• Position the Wall Mount Bracket at the location that it will
go, being sure that it is level, and then drill 4 holes (0.47”dia)
with a 1/2” drill bit, into the wall through the Bracket.
• If mounting to a concrete wall, then use the concrete anchors. If
onto wood or 5/8” (16 mm) plywood, then use the wood screws.
Do not hang the Mascot ST onto
sheetrock unless it is possible to
fasten directly into the structural
studs. If the included anchors
do not suit your installation,
you must use ‘Field Supplied’
anchors that are appropriate
for the wall’s construction.
Wall Mount
Bracket
Bolts (4)
Wall Mount
Bracket
Anchors
*
(4)
3" to Top
of Unit
Concrete,
Wood,
or 5/8" Plywood
4.2.2 Hang the Water Heater
• Lift the water heater up, align the Hangers
on the back of the water heater with the hooks
on the Wall Mount Bracket, and hang the water
heater onto the Wall Mount Bracket. Do a visual
inspection to make sure that the water heater
is hanging properly onto the hooks of the Wall
Mount Bracket.
• Fasten the bottom of the water heater to the
wall using 2 suitable wall anchors (field supplied).
Hangers (2)
(fastened to the back of unit)