Z1
Q
R
2
0
FRONT WHEEL ASSEMBLY (Fig. B)
IMPORTANT:
fixing the front
wheel properly as specified in the
instructions given below is essential for the
proper operation of this fork and all re-
lated devices, and therefore for safe rid-
ing. You are advised to follow these
instructions closely.
Slacken the lock nut of the quick release
lever so the hub will fit between the fork
sliders.
Make sure the quick release bushings (C)
are centered to the recesses in the sliders.
Lock the quick release lever (D) and make
sure the bushings (C) are properly seated
in the sliders.
C
D
WARNING:
These sliders are spe-
cifically designed to fit this type of
hub. Do not use any hub design other than
that specified here, as this would not
ensure proper fastening of the wheel and
may lead to breakdown of the assembly
components.
DISC BRAKE SYSTEM ASSEMBLY
(Fig. C)
Assembling the brake caliper onto the
slider is a very delicate operation that
should be carried out with extreme care.
Improper assembly might overstress the
caliper supports, which might break.
Screw the caliper support (34) to the slider
(19) using the screws (35) and plate (36).
IMPORTANT:
Clean the mating
surfaces inside and outside slider,
otherwise dirt may affect caliper position
or cause the screws (35) to become loose.
Tighten the screws (35) to 9 Nm.
When installing the disc brake system, be
sure to properly follow the instructions
given by the manufacturer.
Nm
9
19
36
35
34
