Fit the extraction washer keeping the blunt side towards the threaded grubscrew (
C
) fixed crosswise on to
the main rod as shown.
The slot in the rod lets the extraction washer swing inside the rod itself.
Insert the extractor in the arch-slider assembly from the side of washer (
B
) as shown.
The slot in the extractor rod will let the washer pass underneath the bush to be extracted.
Pull the extractor rod so that the upper face of the washer stops against the lower face of the guide bush.
Insert the aluminium bush (
A
) in the seat of the sealing ring.
While holding the main rod in position, the aluminium bush will drive the guide bushes during extraction.
Using striker (
D
) knock out and extract the guide bush (
1
).
Remove the guide bush (
1
) from the extractor.
Repeat the steps above to remove the bottom guide bush.
Pull the extractor rod so that the upper face of the washer stops against the lower face of the guide bush.
Insert the aluminium bush (
A
) in the seat of the sealing ring.
While holding the main rod in position, the aluminium bush will drive the guide bushes during extraction.
Using striker (
D
) knock out and extract the guide bush (
1
).
Remove the guide bush (
1
) from the extractor.
Repeat the steps above to remove the bottom guide bush.
© Marzocchi Suspension
2006
-
66 SL
